Previous: QCH(IP)/CH(IP) - Enquire and alter chip type
Up: MISCELLANEOUS COMMANDS
Next: QFI(LES) - Determine current image etc.
Previous Page: QCH(IP)/CH(IP) - Enquire and alter chip type
Next Page: QFI(LES) - Determine current image etc.

QWIN(DOW)/WIN(DOW - Enquire and alter readout window

QWINDOW prints out what the current readout window is. WINDOW alters it.

Parameters

QWINDOW requires none. WINDOW requires four - (XSTART,YSTART) and (XSIZE,YSIZE) respectively. The co-ordinate system is that of the chip relative to (1,1) which is the light sensitive pixel at the corner from which it is read out. (XSTART,YSTART) defines the bottom left hand corner of the read out data and (XSIZE,YSIZE) are its dimensions.

Examples

Adam:> WINDOW 1 385 1 576

Notes

Overscan can be achieved by making XSIZE or YSIZE such that the image exceeds the physical chip dimension.

To restore the default window the easiest course of action is to issue the CHIP command (see Section II.2.4).

*** Note that this resets the pre-flash time to the default set up in the microcode so the SETFLASH command should also be used as well.***


Fri Jun 10 17:31:56 BST 1994