Previous: SEN(D) CON: - Interrupting ADAM
Up: STARTING AND FINISHING
Next: SHUTDOWN - Shut down the system
Previous Page: SEN(D) CON: - Interrupting ADAM
Next Page: SHUTDOWN - Shut down the system
This command can be used to set parameters for a new chip without having to shut down Adam completely. This command is the equivalent of procedures 6 and 7 in the Initialisation Operation (See II.2.2). It can also be used to reset the on-chip binning facility to the default value. (See II.3.11).
There are no parameters
Examples
Adam:> CHIP