Previous: CCD Data Acquisition Software
Up: No Title
Next: Appendices
Previous Page: GLOSSARY OF COMMANDS
Next Page: INTRODUCTION

OPERATION OF THE JKT A AND G BOX

• INTRODUCTION
• INSTRUMENTAL ALIGNMENTS
  • Orientation of the chip
  • Orientation of the A and G Box
  • Instrumental focus
• GENERAL COMMANDS
  • STATUS? - Status of the A and G Box
  • JAGLOAD - Loading D-task for A and G Box
  • JAGINIT - Initialisation of the A and G Box
• AUTOGUIDER
  • FINDSTAR - Find a guide star
  • GDX,GDY, GDXY - Move the autoguider probe
  • X?, Y? - Autoguider probe position status
  • COLOUR - Select autoguider colour filter
  • ND0, ND1 - Select autoguider neutral density filter
  • AGCOLOUR - Select autoguider colour filter
  • AGND - Select autoguider neutral density filter
  • COL? - Status of autoguider colour filter
  • ND? - Status of autoguider neutral density filter
• FILTERS FOR THE CCD CAMERA
  • ZEROSET - Initialise a filter wheel
  • FILTER - Change filter position
  • FILTER? - Filter wheel status
  • WHEEL - Select a filter wheel or input parameters for a new
  • QWHEEL - Lists current wheels and range of available wheels
  • EDITWHEEL - Edits the current wheel parameters
  • EDITTABLE - Edits the filter correspondence table
• ACQUISITION TV COMMANDS
  • TV - Moves TV flat in and opens TV shutter
  • CCD - Closes the TV shutter and moves TV flat out
  • TVSHUT(TER) - Opens and closes the TV shutter
  • TVFLAT - Move TV flat in or out
  • FLAT? - Current TV flat status
  • SHUTTER? - Current TV shutter status
• DRIFT SCAN TABLE COMMANDS
  • DRIFT - Carry out a drift scan run
  • TABLE - Move the drift scan table to position n
  • TABLE? - Drift scan table position status
  • CENTRE - Return drift scan table to its centre position
• GRISM COMMANDS
  • GRISM - Select grism required
• GLOSSARY OF COMMANDS