next up previous contents
Next: ALARMS AFTER A Up: TROUBLE SHOOTING Previous: TELESCOPE RUNAWAY

RELEASING TELESCOPE FROM THE LIMIT SWITCHES

If the actions of Section 9.1 fail, or more likely if you weren't watching or were too slow, then the telescope will be stopped by the horizon limit switches. To get away from this proceed as follows:

  1. Switch telescope to engineering mode.
  2. Press the clear alarm button.
  3. Turn the key marked LIMITS NORM/OVERRIDE clockwise and keep it turned whilst simultaneously pressing whichever of the HA+, HA-, DEC+, DEC- buttons is required. The telescope should now rise away from the limits.

The encoder readings for RA & Dec will probably be corrupted entailing a fresh SNAFU or zeroset.




Tue Aug 5 05:37:08 MET DST 1997