Survey observations
The fields that should be observed are read from the file fields.todo in the
/home/intobs/ha_survey directory. The already observed fields are listed in
the file fields.done in the same directory.
- Copy the correct fields.todo.??? file to fields.todo
- SYS> /home/intobs/ha_survey/survey_noguide_err.csh
- If you want to change the observed sky region, change the fields.todo
file while the Ha or r exposure is being taken or read out.
- To stop the script (after all 3 exposures of a field have been taken),
copy the file empty.dat to fields.todo .
- If you stop the script or change region please make sure that you do this
after the offset field has been observed.
One standard star should be taken in all filters every 2 hours during the
nights observing.
To get a real time display of the frames as they are coming in, use the command
iphas_rtd in IRAF on the data reduction computer.
Note:
If this does not seem to work it is most likely because IRAF was started in the
wrong directory. Exit IRAF (cl>logout), change into the home
directory (csh>cd) and start IRAF again (csh>ecl).
Important
If the seeing is good (<1.7 arcsec) and there are no clouds then the priority
for observing regions is as follows:
- Re-observations of Cat1 fields (Seeing>2.0, ell>0.4, Sky>2000)
- Not yet observed fields
- Re-observation of Cat2 fields (Seeing>1.85, ell>0.3, Sky>1000)
- Re-observation of Cat3 fields (Seeing>1.7, ell>0.2, Sky>500)
Note:Sky value on raw frames is roughly ADU-1900(Bias level).
The fields.todo files are sorted by priority, with not yet observed fields
having highest priority. To find out what the distribution of to be observed
fields per region in the different categories is, run the "region_status.perl"
script.
SYS> /home/intobs/ha_survey/region_status.perl
Observed region status information is available at the
regions status
page.
Try to observe with the following constraints:
- Distance from the moon > 30 degrees (must)
- Airmass < 1.4 (if possible)